How to configure the 1D simulation window to setup an integrated river and urban simulation
- 01 Nov 2022
- 1 Minute to read
- Print
How to configure the 1D simulation window to setup an integrated river and urban simulation
- Updated on 01 Nov 2022
- 1 Minute to read
- Print
Article summary
Did you find this summary helpful?
Thank you for your feedback
When your link-lines have been created, a linked 1D river and 1D urban simulation can be set up.
A new 1D simulation should be defined and the river network details provided on the ‘Files’ tab as you would with a 1D river (only) simulation.
Note
You have now referenced the river network and are ready to run a 1D simulation, however, to run an integrated 1D simulation you will also need to reference the urban network and link-references as shown below.
Details of run-type and timing must be defined on the ‘Times’ tab.
Your urban network and link-reference file are provided on the ‘Links’ tab.
Ensure you save your simulation to keep any changes. Your 1D integrated simulation is now ready to run.
Was this article helpful?