General Headloss
    • 15 Aug 2022
    • 1 Minute to read

    General Headloss


    Article summary

    The General Headloss unit models a generalised channel head loss and can operate either in upstream mode (where flow velocities are obtained from the node upstream of the headloss) or in downstream mode (where flow velocities are obtained from the downstream connected node).

    Data

    Field in Data Entry Form

    Description

    Name in Datafile

    Upstream Node

    Upstream node label

    Label1

    Downstream Node

    Downstream node label

    Label2

    Remote Node

    Remote node label

    Label3

     Loss Coefficient

    Head loss coefficient

    K

    Reverse Flow Mode

    Reverse Flow Mode; keyword ZERO (for zero head loss) or CALCULATED (for calculated head loss)

    rfmode

    Theory and Guidance

    The General Headloss unit models a generalised channel head loss. The General Headloss can operate either in upstream mode (where flow velocities are obtained from the node upstream of the headloss) or in downstream mode (where flow velocities are obtained from the downstream connected node). When in upstream control the General Headloss must be placed immediately downstream of a channel section (for instance a River Section or Conduit type unit). Similarly, when in downstream control, the link must be placed immediately upstream of a River Section or Conduit type node. If these conditions are not rue, you must make use of the Remote Node facility.

    The Remote Node will only be required when there is no channel node in the direction indicated by the "Flow Velocities Obtained From" field. If you set the Remote Node field to point to a River Section or Conduit type node, Flood Modeller will obtain the upstream or downstream flow velocities it requires from this control node.

    The Reverse Flow Mode parameter determines which equation is used in reverse flow. If it set to Calculated, the headloss will use the same equation as for mode 1, but with h1 and h2 reversed. If it is set to Zero then the headloss imposed under reverse flow conditions will be zero. You will always be informed at the start and finish of reverse flow conditions for this unit.

    The General Headloss is identical to the Culvert Bend.

    Equations

    Mode 1 - Positive Flow

    Condition

    Q ³ 0

    Equation

    GeneralHeadlossEqn

    (1)

    where:

    K = Head loss coefficient

    V = Channel flow velocity (derived from the upstream channel in upstream mode, and the downstream channel in downstream mode)

    g =Acceleration due to gravity

    Mode 2 - Reverse Flow

    Condition

    Q < 0

    Equation

    As for Mode 1.

    General

    The unit state for this unit is the current head loss coefficient.

    Datafile Format

    Line 1 - keyword LOSS''

    Line 2 - Label1, Label2, [Label3]

    Line 3 - Keyword UPSTREAM' or DOWNSTREAM'

    Line 4 - K, rfmode

    RiverNodesimagesHeadlossData.gif


    Was this article helpful?

    Changing your password will log you out immediately. Use the new password to log back in.
    First name must have atleast 2 characters. Numbers and special characters are not allowed.
    Last name must have atleast 1 characters. Numbers and special characters are not allowed.
    Enter a valid email
    Enter a valid password
    Your profile has been successfully updated.
    ESC

    Eddy AI, facilitating knowledge discovery through conversational intelligence