Edit river section roughness
    • 04 Aug 2022
    • 1 Minute to read

    Edit river section roughness


    Article summary

    Note that to edit the roughness of River Section nodes (or any other node) within a river network, you must first have the river network Loaded and active.

    Note: this guide refers to the River Section node in particular, however a checkbox enables the same method to apply to Bridge nodes.

    The Toolbox provides multiple options for globally editing parameters. This is accessed via the fourth tab of the right-hand panel group. Click Global Edit and then 1D River Networks to access the Roughness editor tool.

    EditingToolsimagesglobaledit.PNG

    Double-click to open the tool in a new pop-up window.

    Select modifications to apply to the active river network. Note that checkboxes are provided to apply the modifications only where the current roughness value is equal to a specified value (e.g. 0), and to apply the modifications only to selected nodes. Un-check the box(es) provided to apply the specified modifications to all relevant nodes in the network.

    EditingToolsimagesglobaledit2.PNG

    Click OK to apply the modifications. Don't forget to save your network!


    Was this article helpful?

    Changing your password will log you out immediately. Use the new password to log back in.
    First name must have atleast 2 characters. Numbers and special characters are not allowed.
    Last name must have atleast 1 characters. Numbers and special characters are not allowed.
    Enter a valid email
    Enter a valid password
    Your profile has been successfully updated.
    ESC

    Eddy AI, facilitating knowledge discovery through conversational intelligence