How to configure the 1D simulation window to setup an integrated river and urban simulation
    • 01 Nov 2022
    • 1 Minute to read

    How to configure the 1D simulation window to setup an integrated river and urban simulation


    Article summary

    When your link-lines have been created, a linked 1D river and 1D urban simulation can be set up.

    A new 1D simulation should be defined and the river network details provided on the ‘Files’ tab as you would with a 1D river (only) simulation.

    1dsimriver

    Note
    You have now referenced the river network and are ready to run a 1D simulation, however, to run an integrated 1D simulation you will also need to reference the urban network and link-references as shown below.

    Details of run-type and timing must be defined on the ‘Times’ tab.

    Integratedimages1dsimtimes.PNG

    Your urban network and link-reference file are provided on the ‘Links’ tab.

    Integratedimages1dsimlinks.PNG

    Ensure you save your simulation to keep any changes. Your 1D integrated simulation is now ready to run.


    Was this article helpful?

    Changing your password will log you out immediately. Use the new password to log back in.
    First name must have atleast 2 characters. Numbers and special characters are not allowed.
    Last name must have atleast 1 characters. Numbers and special characters are not allowed.
    Enter a valid email
    Enter a valid password
    Your profile has been successfully updated.
    ESC

    Eddy AI, facilitating knowledge discovery through conversational intelligence